Specification:
— Chip: L298N
— Logic voltage: 5V
— Logic current 0mA-36mA
— Storage Temperature: -20 ℃ to ℃ to +135C
— Operating mode: H-bridge driver (dual)
— Drive voltage: 5V-35V
— Drive current: 2A (MAX single bridge)
— Maximum power: 25W
— Dimensions: 43x43x28mm
— Hole dimensions: 3.2 mm, 37 mm spacing
Note:
— This module has a built-in 5v power supply, when the driving voltage is 7v-35v, this supply is suitable for power supply
— DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available.
— When ENA enable IN1 IN2 control OUT1 OUT2
— When ENB enable IN3 IN4 control OUT3 OUT4
Package Included:
— 1 x L298N Stepper Motor Controller
【High Quality】 Main driver chip L298N, strong driving ability, strong anti-interference, low calorific value, after flow diode protection, more stable and reliable for Arduino projects
【Highly Efficient】 Double H bridge design, can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors, high efficient
【Easy to Use】 No assembly required. This L298N board comes ready to go. Just wire up motors and power, easy to use
【Specifications】External size 43*43*28mm / 1.69*1.69*1.06 inch, voltage 5V-35V, drive current 2A (Max single bridge)
【Wide Usage】 Great for for Arduino DIY Smart Car Robot Power UNO MEGA R3 Mega2560 Duemilanove, if driving voltage is more than 12V, use external standard 5volt TTL outputs to switch the H-bridge circuits
Reviews
There are no reviews yet.